Appendix b, Converter parameters, Parameters – dpi drives – Rockwell Automation 1203-USB Converter User Manual
Page 61: Bconverter parameters, Appendix
PowerFlex 1203-USB Converter User Manual
Publication DRIVES-UM001D-EN-P
Appendix
B
Converter Parameters
This appendix provides information about the 1203-USB converter
parameters. The 1203-USB converter (DPI, DSI, and SCANport) combines
the functionality of the 1203-SSS converter (DPI and SCANport) and
22-SCN-232 converter (DSI) in a single device.
Parameters – DPI Drives
TIP: The 1203-USB converter automatically detects the type of device
(DPI, DSI, or SCANport) to which it is connected, and provides a
corresponding set of parameters that are appropriate for the device.
Topic
Page
Parameters – SCANport Drives (DriveExplorer or DriveExecutive software only)
No. Name and Description
Details
01
[DPI Port]
Displays the port on the host drive to which the
converter is connected.
Default:
0
Minimum:
0
Maximum:
7
Type:
Read Only
02
[Reset Module]
No action if set to ‘0’ (Ready). Resets the converter if
set to ‘1’ (Reset Module). Restores the converter to its
factory default settings if set to ‘2’ (Set Defaults). This
parameter is a command. It will be reset to ‘0’ (Ready)
after the command has been performed.
Default:
0 = Ready
Values:
0 = Ready
1 = Reset Module
2 = Set Defaults
Type:
Read/Write
Reset Required: No
03
[Clear DF1 Counts]
No action if set to ‘0’ (Ready). Resets the DF1
statistical
Parameter 04 - [DF1 Packets Sent] and
Parameter 05 - [DF1 Packets Rcvd] to 0 (zero) if set
to ‘1’ (Clear Counts). This parameter is a command. It
will be reset to ‘0’ (Ready) after a ‘1’ (Clear Counts)
command has been performed.
Default:
0 = Ready
Values:
0 = Ready
1 = Clear Counts
Type:
Read/Write
Reset Required: No
04
[DF1 Packets Sent]
Displays the number of DF1 packets sent by the
converter. The value of this parameter is normally
approximately equal to the value of
Parameter 05 -
[DF1 Packets Rcvd].
Default:
0
Minimum:
0
Maximum:
4294967295
Type:
Read Only
!
ATTENTION: Risk of injury or equipment damage exists. If the converter is
transmitting I/O that controls the drive (indicated by a steady green diamond
status indicator), the drive may fault when you remove or reset the converter.
Determine how your drive will respond before removing or resetting a connected
converter.