Rockwell Automation 1203-USB Converter - Manual (Page 13)

Getting Started 1-3
PowerFlex 1203-USB Converter User Manual
Publication DRIVES-UM001D-EN-P
• Compatibility with various drive configuration tools to configure the
1203-USB converter and connected drive as shown below.
• Status indicators to report the operating status of the converter.
• Fixed baud rate of 115.2 kbps.
• Receives power from the connected host drive, eliminating the need for a
dedicated power source.
• Upgradable firmware to get new features as they become available.
Compatible Products
At the time of publication, the 1203-USB converter is compatible with the
following products.
DPI Products
• PowerFlex 70/70EC drives
• PowerFlex 700/700VC drives
• PowerFlex 700 Series B drives
• PowerFlex 700H drives
• PowerFlex 700S drives
• PowerFlex 700L
• PowerFlex 753 drives
• PowerFlex 755 drives
• PowerFlex Digital DC drives
• PowerFlex 7000 drives
• SMC ™
Flex Smart Motor Controllers
• SMC-50 Smart Motor Controllers
• MSR57 Speed Monitoring Safety Relays
Configuration Tool 1203-USB DPI Drive DSI Drive SCANport Drive
Connected Components Workbench
Software, version 1.02 or later
Yes Yes Yes No
DriveExplorer Lite or Full software,
version 4.04 or later
Yes Yes Yes (1)
(1) Except PowerFlex 520-Series drives and Kinetix 3 drives.
Yes
DriveExecutive software,
version 1.01 or later
Yes Yes Yes (1) Yes
Terminal emulation software,
such as HyperTerminal
Yes not recommended
TIP: Also check the supported products by the various drive software
tools. For example, the PowerFlex 520-Series drives and Kinetix 3 drives
are only supported by Connected Components Workbench software and not
DriveExplorer or DriveExecutive software.