Rockwell Automation 2711 PanelBuilder 1200 Transfer Utility - Manual (Page 51)

Transferring Application Files with
Chapter 5
User PROMs
5-8
Important After you download a large file to a terminal that has a 128K
EEPROM installed, it can take up to 40 seconds for the application file
to be loaded into the EEPROM. The Transfer Utility will show the
download as completed, but the message “Transmitting...” continues to
flash on the PanelView 1200 screen while the application file is loaded
into the EEPROM. Wait for at least a minute after the download is
reported as completed before you attempt to use the terminal.
Via PROM burner—To program an EPROM or EEPROM with a
PROM burner, follow the steps outlined in the previous sections, “Burn
EPROMs” or “Burn Single EPROM”.
The PROM burner must have its own download utility software, and
must be able to program a 28C256, 28C512, or 27C010, type EEPROM.
Refer to the instructions provided with your PROM burner for the
download utility procedure. Once programmed, the EEPROM(s) can be
installed in the empty PROM socket(s) in the PanelView 1200 terminal.