Rockwell Automation 2711 PanelBuilder 1200 Transfer Utility User Manual

Page 28

Transferring Via the Data Highway Plus

Chapter 4

and Remote I/O

4-2

PLC Controller Series/Revision Requirements

Verify that your PLC controller can perform Pass-Through file transfers.
The following table lists the PLC controller series and revisions that
support Pass-Through file transfers.

Processor

Series

Revision

PLC-5/11

All

PLC-5/15

N or later

PLC-5/20

All

PLC-5/25

J or later

PLC-5/30

B or later

PLC-5/40

A
B

E or later
B or later

PLC-5/60

A
B

E or later
B or later

PLC-5/250

All

This table lists the PanelView 1200 hardware and firmware revisions, and
PanelBuilder software revisions that are required for Pass-Through:

ББББББББББББ

PanelView 1200 Hardware

ББББББББББББ

Series A, Rev B or later

ББББББББББББ

PanelView 1200 Firmware

ББББББББББББ

Version 3.0 or later

ББББББББББББ

PanelBuilder Software (for DOS)

ББББББББББББ

Version 3.0 or later

PanelBuilder 1200 Software (for Windows)

Version 5.0 or later

PanelView 1200 Transfer Utility Software

Version 5.01 or later

Pass-Through Utility

Version 3.01 or later

To download an application file over the Data Highway Plus and Remote
I/O networks to the PanelView 1200 terminal you must follow these steps:

Configure the file’s Pass-Through parameters in PanelBuilder.

Configure the Pass-Through parameters in the PanelView 1200 terminal
if you’re using the manual configuration. If the existing application is
already set up in the terminal you don’t need to do this.

Prepare the PanelView 1200 Transfer Utility for downloading.

Define the PanelView location data.

Define the Programming Terminal Configuration.

Download the application file.

This chapter offers detailed instructions on each of these steps.

Downloading Application Files
over Data Highway Plus