Rockwell Automation 2711 PanelBuilder 1200 Transfer Utility - Manual (Page 14)

Setting Up the PanelView 1200
Chapter 2
Transfer Utility
2-5
4. A window appears, recommending you close all open Windows
applications. If you followed step 1, choose Next; otherwise close all
open Windows applications, then choose Next. The File Transfer
Utility Installation Program runs automatically.
5. In the registration window, enter registration information about your
copy of the FTU. Registration information is on the software
registration card in your PanelBuilder 1400e or PanelView
1200/1400e Transfer Utility package.
6. Choose the drive and directory in which the FTU will be installed. By
default, this is C:\AB\PB1400E\FTU. To change the destination drive
or directory, type the new drive and/or directory in the Program Files
box. Then choose Next.
7. Choose the program folder (program group) in which you want to
install the FTU’s icons, which include a Readme file icon, the
Transfer Utility icon, and an Uninstall icon. By default, the icons are
installed in the PanelBuilder 1400e program folder. Then choose
Next.
8. Choose whether the installation utility will modify the
AUTOEXEC.BAT file. The entry
C:\RSI\CMN
is required in the PATH variable for the FTU to work correctly.
Choose Next to approve the changes and continue.
9. The setup utility shows a summary of the choices you made in the
preceding dialog boxes. To make any changes, choose the Back
button. Otherwise, choose Next to begin the installation.
10. After all the applications have completed installing, you are prompted
to reboot your computer. You may reboot immediately or later, but
you must reboot before you can run the Transfer Utility or other
applications successfully.