Rockwell Automation 1794-XXXX FLEX I/O High-Density Analog Modules - Manual (Page 15)

7 Publication 1794-UM062A-EN-P - September 2012
Chapter
2
Install Your FLEX I/O Module
Overview This chapter provides you with pre-installation requirements and instructions on
how to install your FLEX I/O analog module.
Before You Install Your
Module Before installing your FLEX I/O analog module, you need to:
• Calculate the power requirements of all modules in each chassis,
• verify that a suitable enclosure is available for installation of the module,
and
• position the keyswitch on the terminal base.
Power Requirements The wiring of the terminal base unit is determined by the current draw through
the terminal base. Make certain that the current draw does not
exceed 10 A.
Topic Page
Before You Install Your Module 7
Power Requirements 7
Install the Module 9
Wire the Terminal Base Unit 15
Connect Wiring to the FLEX I/O Module 16
ATTENTION: Total current draw through the terminal base unit is
limited to 10 A. Separate power connections may be necessary.
ATTENTION: Do not daisy chain power or ground from the terminal
base unit to any AC or DC digital module terminal base unit.