Rockwell Automation 2755-SNx Adaptascan Bar Code Readers - Manual (Page 347)

17–25 Communicating with PanelView 900
t
Terminals on a DeviceNet Network
Publication 2755-6.8
This application provides an example of using explicit-client
messages to monitor decoded bar code data and change attributes of
an AdaptaScan Bar Code Reader. The AdaptaScan is connected
directly to the PanelView.
PanelView 900
AdaptaScan Reader
Power Supply
(Catalog No. 2755-PW46)
The DeviceNet network must be supplied with power. In this
application, you can use the AdaptaScan power supply (Catalog No.
2755–PW46). The power supplies used with DeviceNet are sized to
the number of devices and DeviceNet cable lengths. Review your
DeviceNet literature for DeviceNet network configuration data.
Note: AdaptaScan software version 7.0 or later with reader
firmware 7.0 or later is required to run this application.
Connections
The PanelView connects directly to the DeviceNet terminal block in
the AdaptaScan wiring base. Refer to Publication No. 2755-837 for
DeviceNet and power supply connections.
AdaptaScan Application