Rockwell Automation 2755-SNx Adaptascan Bar Code Readers - Manual (Page 34)

2–7 Using ASCII Command Input
Publication 2755-6.8
3. Click the Edit button to open the ASCII Command Input dialog.
The default ASCII commands for triggering the decoder are two
character commands:
•
BS (Begin Scan)
•
ES (End Scan)
This application uses one character ASCII commands to trigger
the decoder.
•
B (Begin Scan)
•
E (End Scan)
4. In the Turn On field, type the letter B. (The command is case
sensitive.)
5. In the Turn Off field, type the letter E. If you do not use an E in
the Turn Off field, the trigger will then turn off in 1000 ms. (The
command is case sensitive.)
6. Click the OK button.
7. Click the Save button to save the ASCII command definitions.
8. Click the Close button and return to the main Project dialog.