Rockwell Automation 2755-SNx Adaptascan Bar Code Readers - Manual (Page 323)

Chapter
17
Publication 2755-6.8
Communicating with
PanelView 900t Terminals on
a DeviceNet Network
This application describes how to connect and configure
communications for the DeviceNet versions of the PanelView 900
terminals. This document provides supplemental information for the
PanelBuilder Software User Manual (Publication No. 2711-6.0).
The hardware items required for this application are:
•
2755-SN3, -SN5 or -SN8 AdaptaScan Bar Code Reader
•
2755-NB40 or -NB41 Wiring Base
•
2755-PW46 or -PW47 Power Supply (if not power by DeviceNet)
•
2755-NC43 or -NC48 Configuration Cable
•
DeviceNet trunk cable
•
2711-K9C10, -T9C10, -K9A10, or -T9A10 PanelView 900
terminal
•
1747-L532, -L541, -L542, or -L543 SLC Processor or 1785
PLC-5 processor and appropriate chassis
•
1747-SDN Scanner Module (v2.05 firmware or later) or
1771-SDN Scanner Module (v3.04 firmware or later)
•
Computer running Windows 3.1 (or later) or Windows 95
•
9-to-25 Pin Adapter (for Computer with 25-pin COM port)
The software requirements for this application are:
•
2755-ASN AdaptaScan Offline Programming Software (v8.0 or
later)
•
PanelBuilder
t software
•
6200 Series Programming Software or SLC Advanced
Programming Software
•
1787-MGR DeviceNet Manager Software (v3.0 or later)
Introduction
Hardware Requirements
Software Requirements