Rockwell Automation 2755-SNx Adaptascan Bar Code Readers - Manual (Page 256)

13–2 Communicating with a 2760-RB Module over an RS-232 Link
Publication 2755-6.8
Publications you might want to refer to include:
Publication Description
2755-837 AdaptaScan Bar Code Readers User Manual
2755-838 AdaptaScan Software User Manual
2760-ND001 2760-RB Interface Module User Manual
2760-ND003 2760-SFC1 Protocol Cartridge User Manual
2760-822 2760-SFC2 Protocol Cartridge User Manual
In addition, you may want to refer to the PLC-5 Hardware and
Software User Manuals.
Refer to the following table for hardware compatibility in this
application example.
th following
with the following PLC-5 type
Use the following 2760-RB
Interface Module type
PLC-5, -15, -25, etc.
New Generation PLC-5
(Series A, Rev. C or above)
Series A, Rev. G or below
Refer to the sample PLC-5
Refer to the sample PLC-5
program on page 13–6.
(Set BT compatibility bit
S26/4 while in program
mode.)
Series A, Rev. H or above
Refer to the sample PLC-5
program on page 13–6.
Refer to the sample PLC-5
program on page 13–7.
(Add ladder logic using IIN
update of RB. BTR must be
before BTW.)
The 2760-RB configuration example includes sample configuration
screens and DIP switch settings needed to establish communication
with the AdaptaScan Reader via RS-232.
Dip Switch Side View
Switch pushed toward
bottom (on position).
Switch pushed toward
top (off position).
Related Publications
PLC-5 Compatibility
Connecting the RB Module
to the Reader