Rockwell Automation 2755 AdaptaScan Software - Manual (Page 71)

4–24 Getting Started
Publication 2755-838
3. Click the Edit button.
The Message Field Edit dialog opens. Make the following edits:
1. Set length to 14
2. Leave blank
3. Enter NO–READ
as the Fail string
Note: If you leave the Pass String field blank, all of the decoded bar
code data is placed in the message string. You could enter a string
like Good Read that would be placed in the data message whenever
a UPC label is decoded. The Fail String NO-READ is placed in a
message when a label is decoded that does not match the content of
the Find String (see previous page).
4. Click OK to exit and return to the Message dialog.
5. Click the Format button on the Message dialog.
The Message Format dialog opens. Make the following edits:
1. Enter \n as
the header.
2. Enter \r as
the trailer.
3. Make sure
Serial Port
is selected.
Note: \n = Line Feed, \r = Carriage Return
6. Click OK to exit and return to the Message dialog.
7. Click Save and then Close to save the message definition and
return to the Project 1 window.