Rockwell Automation 2755 AdaptaScan Software - Manual (Page 185)

13–6
Publication 2755-838
The AdaptaScan printout provides detailed information on the
contents of a project including
Heading: Provides:
Label Setup Symbols per Scan
Quiet Zone Ratio
Negative Image
Symbol Name
Symbology
Reader Configuration DeviceNet Address
Baud Rate
Description
Heartbeat Rate
Enable Warning
Scanner Laser Light
Scanner Mode
Scan Width
Elevation
Upper Angle
Lower Angle
Increment
Flyback Enabled
Focus Range Units
Decoder Capture Count
Self Triggered Enable
Input Trigger
Label Setup
Low Limit
Scanner Metric
Inter–Symbol No–Read Count
I/O Name
Input or Output
Cyclic On Time
Cyclic Off Time
Delay On
Delay off
Limits (Maximum & Minimum)
Serial Port Scanner Protocol Enabled
Enable Pass–Through to DNet
Terminal Protocol Settings
DF1 Protocol Settings
DH–485 Protocol Settings
Match Table Trigger Input
Package Trigger
Package Setup Configuration
Match Configuration
Message Enable/Disable
Trigger When
Format
Destination
Printout Contents