Rockwell Automation 2755 AdaptaScan Software - Manual (Page 40)

3–2
Publication 2755-838
The Go On-Line command establishes communications between the
AdaptaScan software and DeviceNet network using the
communication channel specified on the Preferences dialog (see
page 2–18).
To go on-line with AdaptaScan software:
1. Click the Go On-Line icon or select Go On-Line from the
Communications menu.
The project window will display the devices on the network along
with their catalog number and address.
Note: The Query dialog may be displayed when you go on-line
(depending on your preference settings). Refer to page 2–19.
Note: If you are connected to the DeviceNet network using the
Reader configuration cable, only AdaptaScan Readers on the
network are identified and displayed. When connecting using a
DeviceNet communications card and driver software on your
computer, all DeviceNet nodes on the network are identified and
displayed.
2. Highlight individual readers in the list to display the currently
loaded firmware revision and their configuration status.
Going On-Line
Go On-Line