Rockwell Automation 1746-BAS-T SLC 500 Basic Basic-T Modules User Manual
Page 21

Publication 1746-UM004B-EN-P - December 2005
Module and Development Software Overview 1-9
Figure 1.5 BASIC Development Software Interface (RS-232)
In this configuration, the serial port on the personal computer is
connected to port PRT1 on the module. The personal computer
communicates with the module through terminal emulation over an
RS-232 interface. Port PRT1 must be configured as the program port.
See Chapter 3 for additional information on port configuration.
BASIC Development Software Interface (DH485)
In this configuration, the serial port on the personal computer
interfaced with port DH485 on the module through a 1747-PIC
interface/converter. Port DH485 must be configured as the program
port with DH485 protocol.
See Chapter 3 for additional information on port configuration.
Figure 1.6 BASIC Development software Interface (DH485)
Personal Computer with BASIC
Development Software
Null Modem
Cable
SLC 500 Controller with BASIC or BASIC-T Module
IMPORTANT
When using the BASIC development software to
interface with the RS-232 port of the module, PBASE
must be configured for RS-232 communication
through the configuration and terminal selection
menus. Refer to the BASIC Development Software
Programming Manual, publication 1746-PM001, for
additional information.
ASCII Terminal or Personal
Computer Running ASCII
Terminal Emulation Software
Interface/Converter
RS-232 to RS-485
Catalog Number 1747-PIC
SLC 500 Controller
with BASIC or
BASIC-T Module