Chapter summary and what’s next, Going online – Rockwell Automation 1734-ADNX POINT I/O DeviceNet Adpater User Manual User Manual
Page 72
Publication 1734-UM002C-EN-P - July 2003
5-6 Adding the 1734-ADN(X) to the DeviceNet Scanner’s Scanlist
Going Online
Follow these steps for the adapter to go online:
1. Use the Network pull-down.
The software prompts you to save your configuration changes.
2. Choose your adapter’s network as shown below.
3. Apply the data to your adapter.
To learn how to add the 1734-ADN(X) to the scanner’s scanlist, refer
to the Quick Start section, Appendix B.
Chapter Summary and
What’s Next
In this chapter, you learned how to configure the adapter. Move to
Chapter 6 if you need troubleshooting assistance.
1. Click on Network.
2. Click on Online.
1. Click on Yes.
1. Select the DeviceNet
interface.
2. Select the DeviceNet
Network subnetwork.
This selection accesses
the Subnet to configure
the adapter on the
DeviceNet network.
3. Click here.