3 - using auto start mode, Using auto start mode, Chapter – Rockwell Automation 1734-ADNX POINT I/O DeviceNet Adpater User Manual User Manual
Page 45

1
Publication 1734-UM002C-EN-P - July 2003
Chapter
3
Using Auto Start Mode
This chapter describes how to use the Auto Start Mode with your
POINT I/O DeviceNet adapter.
This chapter assumes you already have a DIN rail installed for your
POINT I/O system. There are five simple steps to the Auto Start Mode:
For more information on:
See page:
Adding Non-Backplane Modules to Subnet (1734-ADNX Only)
Chapter Summary and What’s Next
Adapter
Status
DeviceNet
Status
Subnet
Status
1734-ADNX
Field
Power
System
Power
24VDC
Source
Output
Module
Status
Network
Status
1734
OB4E
NODE:
0
1
2
3
4. 1734-ADNX Only
Add and Commission
Non-Backplane I/O
Modules to the Subnet
This manual is related to the following products: