Rockwell Automation 1771-OFE/B Analog Output Module User Manual - Manual (Page 25)

2-11
Publication 1771Ć6.5.30 - November 1998
The front panel of the module contains a green RUN and a red FLT
(fault) indicator. At power-up, the red FLT indicator lights and
remains ON during an initial module self-check. If a fault is found
initially or occurs later, the red FLT indicator stays lit. If a fault is
not found, the red indicator will turn off and the green RUN
indicator will turn on and remain on.
Possible module fault causes and corrective actions are discussed in
Chapter 7, “Diagnostics and Troubleshooting.”
Figure 2.7
Diagnostic Indicators
ANALOG
OUT
(12 BIT)
RUN
FLT
17948
In this chapter, you learned how to set the module configuration
jumpers, connect the field wiring to the field wiring arm, and install
your module in the I/O chassis.
Interpreting the Indicator
Lights
Chapter Summary