Rockwell Automation 1336-GM1 Remote I/O Communications Module - Manual (Page 37)

Installing the Module 3–7
4. Screw the four stand-off nylon headers into the appropriate
spaces on the drive main control board.
Figure 3.6 Mounting the Open Style Communications Board
5. Insert the SCANport connector into the 14-pin SCANport header
on the control board. The DIP switches should be facing you.
6. Screw the board securely into place, being careful not to
overtighten the four screws.
7. Connect the Remote I/O cable.
Figure 3.7 Connecting the Remote I/O Cable
J4
Blue
Shield
Clear
1
SH
2
Blue
Shield
Clear
.
..
1
SH
2
1336-GM1
Board
.
SCANport Product
PLC Controller