Brother FAX 770 - Manual (Page 29)

19
I N S T A L L A T I O N
Do not connect a TAD elsewhere on the same phone line—your FAX/MFC
and TAD will both try to control the line.
Connections
The external TAD must be plugged into the left side of the FAX/MFC, into the
jack labeled EXT. Your FAX/MFC cannot work properly if you plug the TAD into
a wall jack.
1 Plug the telephone line cord from the wall jack into the left side of the
FAX/MFC, in the jack labeled LINE.
2 Plug the telephone line cord from your TAD into the left side of the
FAX/MFC, in the jack labeled EXT. (Make sure this cord is connected
to the TAD at the TAD’s telephone line jack, and not its telephone set
jack.)
3 Set your external TAD to four rings or less. (The FAX/MFC’s Ring
Delay setting does not apply).
4 Record the outgoing message (see below).
5 Set the TAD to answer calls.
6 Set Message Storage ( Function , 8 , 1 ) to VOICE:EXT.
(For FAX 870MC and MFC 970MC only).
7 Set the Answer Mode to TAD:ANSWER MACH.
(For FAX 750 and FAX 770 only.)
On the FAX 870MC and MFC 970MC, set the Answer Mode to
MC:MSG CTR.