Rockwell Automation 442L-SFZNMN SafeZone Mini Safety Laser Scanner User Manual - Manual (Page 17)

Rockwell Automation Publication 10000337275 Ver 01—October 2014 15
Chapter 4 Configurable functions
Chapter
4
Configurable functions
System parameters A name can be assigned to the application configured as well as to the safety laser scanner(s). The names are saved in the
devices after the configuration is transferred. The name chosen may be, for example, the identifier for the vehicle, system
or the machine.
You enter the application name and the names of the safety laser scanners used in the SCD software.
Application name
Enter a name for your application. You can enter a name with a maximum of 16 characters.
If you assign unique application names, you may “reserve” the devices for certain duties. A machine maintenance person
comparing exchanged devices with the configuration data saved in the SCD software will be notified that the application
name does not match. He may then exchange these devices for those with the correct application name.
Name of the scanner
Enter a device name for each of the safety laser scanners in the system. You can enter names with a maximum of eight
characters.
Recommendation Use meaningful names, e.g. “front” and “rear” for vehicle monitoring. Unique device names make the subsequent
configuration steps easier (for example on allocating the control inputs or the OSSDs).
User data
You can enter your name in the field Name of the user. You can enter a name with a maximum of 22 characters. This is
then added to the configuration protocol and in the diagnostics report.
Display direction of the seven­segment display
The depiction of numbers on the seven­segment display can be rotated by 180° with the aid of the SCD software. This is
useful, for example, when the SafeZone Mini must be rotated by 180° owing to the specific assembly.
If you rotate the numbers of the seven­segment display, the point in the seven­segment display goes out.
How to determine the display direction of the seven­segment display:
 Under seven­segment display, activate the Rotated by 180° option. After the configuration draft has been
transferred to the SafeZone Mini, the numbers of the seven­segment display are rotated by 180°.