Yamato Scientific IN803 Low Temperature Incubators - Manual (Page 45)

41
Operation Method
Set the Operation Stop Signal Input Mode
1 Select the item in function menu
• Check that the power in turned on.
FUNCTION
TROUBLE
ENTER CANCEL
Stop signal OFF
①
Press the FUNCTION key. The function menu
starts and the Sub Display displays the items.
Select the item using the FUNCTION key.
②
Display the "Stop signal" and press the ENTER
key.
™ Press the CANCEL key to cancel the function menu.
2 Select mode
Stop signal OFF
↓
Stop signal ON
①
The "" (cursor) goes out and the mode currently
selected blinks instead. Display the "ON" or
"OFF" using the "▼▲".
3 Set operation stop signal input mode
TROUBLE
ENTER CANCEL
Stop signal ON
①
Press the ENTER key. The operation stop
signal input mode is decided and the function
menu selection screen is displayed.
• The unit monitors the input of operation stop signal
during operation in each mode and automatically
stops operation if it is input when the operation
stop signal input mode is set to "ON". The unit
enters to the standby state.