Yamato Scientific IN803 Low Temperature Incubators - Manual (Page 33)

29
Operation Method
Input Program
2 ① After the step number is decided, the setting item selection screen is displayed. Select the
items on the Sub Display using the PROGRAM key.
™ The step number currently edited is displayed on the lower column of Sub Display. The details for all
registered steps in use are displayed followed by all un-used steps.
™ The "Set TEMP" for the next step follows the "Program End". The screen, in this way, displays the
details of respective steps in sequence. The unused steps are displayed at the end if other steps are
used. The display "un-used" is added at the end of step number displayed in the lower column of
Sub Display for un-used steps. All steps subsequent to the step with "un-used" are un-used steps.
• The setting items are not displayed on the screen depending on the setting conditions shown
below.
™ It is impossible to change the content of program currently operated. Checking it is possible.
No. Item Sub Display Notes
1
Setting
temperature
Set TEMP 37.0℃
S01
2 Setting time
Set time 0min
S01
3
Repeat
initiating step
Rep. start S01
S01
4 Repeat count
Rep. count 5
S01
5 Step insertion
Insert step
S01
Add a new step at the position of step
currently referred to. The sequence number
of each step hereafter increases by one.
6 Step deletion
Delete step
S01
Delete the step currently referred to. The
sequence number of each step hereafter
decreases by one.
7
Program end
Program End
S01
Complete program registration/edition.
Setting item Not displayed in the following condition
Setting temperature Not displayed when the setting time is set to "End".
Repeat initiating step
Not displayed when the period is set to "End" or when the
other step is inserted in the specified repeat interval.
Repeat count
Not displayed when the repeat initiating step is not
displayed, or "No" is set.
Step insertion Not displayed when steps are left.