Yamato Scientific IN803 Low Temperature Incubators - Manual (Page 26)

22
Operation Method
Auto Start Operation
As shown in the following figure, this mode is applied to the device for starting the operation after
the specified time (hours) automatically. Note that the device does not stop the operation
automatically. Stop the operation by manual without fail.
Setting of the Auto Start Operation
1 Turn on the power
POWER
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER FUNCTION PROGRAM MENU ENTER CANCEL
POWER
TROUBLE
℃
Standby
2002/01/01 12:00
REFRIGE
DEFROST
• Turn on the power switch of the unit (earth leakage
breaker). Pressing the POWER key turns on the
power. The Main Display indicates the
temperature in furnace. The Sub Display
indicates "Standby" and the STANDBY lamp lights
on.
2 Select operation mode
MENU
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER FUNCTION PROGRAM MENU ENTER CANCEL
POWER
TROUBLE
℃
Auto-start OPR
Select OPR mode
REFRIGE
DEFROST
①
Pressing the MENU key displays the operation
mode selection screen.
② The Sub Display on the operation mode selection
screen displays the name of operation mode
currently selected with blinking. The
corresponding operation mode lamp blinks at the
same time.
③ Keep pressing the MENU key until the auto start
operation mode is displayed.
④ Press the ENTER key. The auto start operation
mode is decided.
™ The fixed temperature operation is selected at the
initial setting of unit. The operation mode carried
out last is selected in case other than it.
SV: Setting temperature
t:
Time
t
Set timer
▼
Activate Timer
Start operation (Auto)
Activate controller (Manual)
SV