Yamato Scientific IN803 Low Temperature Incubators - Manual (Page 38)

34
Operation Method
Program Creation Example
11 Press the PROGRAM key to display the "Rep. start".
Rep. start ► No
S01
12
Press the ENTER key to display the repeat initiating step edition
screen. The cursor goes out and the setting for repeat initiating
step blinks.
Rep. start No
S01
13 Set the "No" using the "▼▲".
Rep. start ► No
S01
14
Press the ENTER key to decide the setting.
Rep. start ► No
S01
15 Press the PROGRAM key until the "Set TEMP" in the Step 2 is
displayed. The display on the lower column changes from "S01"
to "S02"or to "SO2 (un-used)".
Set TEMP ► 0.0℃
S02
16 Press the ENTER key to display the setting temperature edition
screen. The cursor goes out and the setting temperature blinks.
Set TEMP 0.0℃
S02
17 Set the temperature to 20℃ using the "▼▲"
Set TEMP 20.0℃
S02
18
Press the ENTER key to decide the temperature.
Set TEMP ► 20.0℃
S02
19
Press the PROGRAM key to display the "Set time" selection
screen.
Set time ► 0min
S02
20
Press the ENTER key to display the setting period edition screen.
The cursor goes out and the setting period blinks.
Set time 0min
S02
21 Set the period to 0 min using the "▼▲".
Set time 0min
S02
22
Press the ENTER key to decide the period.
Set time ► 0min
S02
23
Press the PROGRAM key to display the "Rep. start".
Rep. start ► No
S02
24
Press the ENTER key to display the repeat initiating step edition
screen. The cursor goes out and the setting for repeat initiating
step blinks.
Rep. start No
S02