Yamato Scientific IN803 Low Temperature Incubators - Manual (Page 35)

31
Operation Method
Input Program
3 Insert step into the position currently displayed
①
Display the "Insert step" on the setting item selection screen and then press the ENTER key.
The screen returns to the setting item selection screen and the setting temperature of inserted
step is displayed.
™ The "Insert step" is not displayed if no steps are left.
TROUBLE
ENTER CANCEL
Insert step
S01
→
TROUBLE
ENTER CANCEL
Set TEMP 0.0℃
S01
(Decide the input) (Selection screen)
™ The initial settings below are set in the newly inserted step. The settings of "un-used" steps displayed
at the end of "Select step" are the same as that listed below.
Item Initial setting
Setting temperature 0℃
Setting time 0 minute
Repeat initiating step No
4 Add step at the end of program
①
Display the setting of un-used step on the setting item selection screen and then press the
ENTER key.
TROUBLE
ENTER CANCEL
Set TEMP 0.0℃
S23(un-used)
™ The "SO1" (the first step) indicates "un-used" at the first registration of program.
™ The items other than "Insert step", "Delete step" and "End program" can be set.
™ The "un-used" steps are not displayed if no steps are left.
② Change the setting value and press the ENTER key.
③ The indication "un-used" on the lower column of Sub Display goes out.
Set TEMP ► 0.0℃
S23