Yamato Scientific IN803 Low Temperature Incubators - Manual (Page 21)

17
Operation Method
Fixed Temperature Operation
3 Set temperature
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER FUNCTION PROGRAM MENU ENTER CANCEL
POWER
TROUBLE
℃
Set TEMP 0.0℃
Fixed TEMP OPR
REFRIGE
DEFROST
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER FUNCTION PROGRAM MENU ENTER CANCEL
POWER
TROUBLE
℃
Set TEMP 37.0℃
Fixed TEMP OPR
REFRIGE
DEFROST
① The setting temperature input screen is
displayed. The Sub Display indicates "Set
TEMP" and the numeric character that indicates
temperature blinks.
② Set the temperature using the "▲▼".
③ Press the ENTER key to decide the temperature
and start the fixed temperature operation.
CAUTION!
™ The refrigerator operation can not be performed
again for five minutes just after an operation stop.
The refrigerator has been in the standby state and
the REFRIGE lamp blinks during the period.
Start operation
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER FUNCTION PROGRAM MENU ENTER CANCEL
POWER
TROUBLE
℃
Set TEMP 37.0℃↑
Fixed TEMP OPR
REFRIGE
DEFROST
① The blinking FIXED TEMP lamp lights on when
the fixed temperature operation starts. The unit
starts to control temperature according to the
setting temperature. The HEATER lamp lights
on when the heater is on and The REFRIGE lamp
lights on when the refrigerator is on.
② The Sub Display displays the setting temperature.
The arrow which indicates the state of
temperature control is also displayed with
blinking. The direction of arrow shows as
follows depending on the relation between the
setting temperature at operation start and that in
furnace.
Set TEMP 37.0℃↑
2002/01/01 12:00
Set TEMP 37.0℃↓
2002/01/01 12:00
(When setting temperature is
higher than temperature in
furnace) (When setting temperature is
lower than temperature in
furnace)
③ The direction of arrow shows as shown below
when the temperature in furnace reaches to
within ±1.0℃ of setting temperature.
Set TEMP 37.0℃→
2002/01/01 12:00
(When temperature in furnace
reaches to around setting
temperature)
4
POWER
④ Press the POWER key to stop operation.