Yamato Scientific IN803 Low Temperature Incubators - Manual (Page 30)

26
Operation Method
Program Operation
4 Start operation
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER FUNCTION PROGRAM MENU ENTER CANCEL
POWER
TROUBLE
℃
Step S01
Start in 30min
REFRIGE
DEFROST
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER FUNCTION PROGRAM MENU ENTER CANCEL
POWER
TROUBLE
℃
Set TEMP 37.0℃↑
Step S01
REFRIGE
DEFROST
①
Press the ENTER key to decide the operation
start wait period/time. The unit enters to
program operation wait state. The blinking
PROGRAM lamp lights on and the STANDBY
lamp blinks instead in this state. The Sub
Display displays the step number and residual
time to operation start.
② The operation starts when the residual time
counts zero. The STANDBY lamp lights off and
the Sub Display displays the executing step
number and the setting temperature after the
operation starts.
③ The following screens are displayed in sequence
during operation.
Set TEMP 37.0℃↑
Step S01
(Executing step number)
↓
Set TEMP 37.0℃↑
Remain 15min
(Remaining time)
↓
Set TEMP 37.0℃↑
Rep. count 10
(Residual count of repeat:
displayed during repeat only)
↓
Set TEMP 37.0℃↑
Wait 5min
(Waiting state: displayed
during wait only)
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER
REFRIGE
FUNCTION PROGRAM MENU ENTER CANCEL
DEFROST
POWER
TROUBLE
℃
Stop time
2002/01/01 12:30
④ The END lamp blinks and the Sub Display
displays the operation finish time when the
operation stops.
⑤ Press the POWER key to cancel the operation or
quit the wait state.