SDC 480-4SB SQUARE SURFACE/FLUSH MOUNT BOX - Manual

INSTALLATION INSTRUCTIONS
480-4SB & 480-4FB
SQUARE SURFACE/FLUSH MOUNT BOX
FOR 4-1/2” SWITCHES
P:\INSTALLATION INST\WIKK\INST-480-SQ.vsd REV - 01-13 Page 1
801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •
www.sdcsecurity.com • E-mail: [email protected]
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email [email protected]
Parts included with mounting boxes: >Black ABS surface or flush mount box >Transmitter mounting
pins >9V battery mounting clip >Mounting instructions >Weather resistant gasket
480-4SB SURFACE MOUNT: Hollow Wall or Solid Wall (illustration #1) 1] Drill pilot holes in mounting box
(placement indications are in box). 2] Drill pilot holes in mounting surface. 3] Insert appropriate fastener
(screw, toggle, etc.) through box and into mounting surface; tighten. 4] Insert Weather Resistant Gasket.
5] Complete installation of switch.
480-4FB FLUSH MOUNT: Hollow Wall ONLY (illustration #2) 1] Cut 5-5/8” x 5-5/8” access hole into
mounting surface. 2] Insert box into the hole. 3] use the two Phillips head screws to tighten the silver
hanger to the mounting surface. 4] Insert Weather Resistant Gasket. 5] Complete assembly of the switch.
MOUNTING
BOX
CROSS SECTIONAL VIEWS
ADJUSTMENT
SCREW
FLUSH
MOUNT
BRACKET
SOLID WALL
ANCHOR
MOUNTING
BOX
HOLLOW
WALL
ANCHOR
MOUNTING
BOX
ILLUSTRATION #2
ILLUSTRATION
#1
HOLLOW WALL
SURFACE
MOUNT
SOLID WALL
SURFACE MOUNT
HOLLOW WALL
FLUSH MOUNT