beautypg.com

SDC LR100DHK ELECTRIC LATCH RETRACTION KIT DESIGN HARDWARE 1000R, 1000V User Manual

Page 2

background image

NOTE Retro-Fitting Vertical Rod Devices:

Before retro-fitting an electric latch assembly into a vertical device, the following must be done
to ensure proper alignment. Disconnect the vertical rods from the device. Install the electric
latch assembly as shown above. Once the ELR is properly installed energize it so that the
push pad is dogged down, by doing so it will allow for proper alignment for the vertical rods.
Finally reconnect the vertical rods to the device and make the proper adjusments.

AFTER ATTACHING LINKAGE, POWER THE
UNIT. THIS WILL CAUSE THE E.L.R. TO PULL
INTO THE EXIT DEVICE. DEPRESS THE PUSH
PAD TO PROPERLY POSITION THE E.L.R.
MANUALLY PULL THE E.LR. ASSEMBLY BACK
TIGHTEN THE SET SCREWS TO LOCK THE
E.L.R. IN PLACE. TEST FUNCTION OF E.L.R. BY
APPLYING POWER TO VERIFY THAT THE E.LR.
ASSEMBLY RETRACTS THE PUSH PAD AND
LATCH

P:\INSTALLATION INST\SWITCH KITS\INST-LR100DHK.vsd REV -

07-14 Page 2