MTS Criterion 40 - Manual User Manual

Page 63

Single-Column Load Frame

MTS Criterion

Series 40 Product Manual

Installation

1. Remove the rubber mat (Item 9), the sheet metal cover (Item 14), and the

handset component (Item 8) from the frame. Disconnect the cable with the
handset; remove the aluminum column from the frame.

2. Cut the slits for the enclosure legs on the rubber mat (Item 9) with a knife.

3. Position the right-side panel assembly (Item 7) on the frame base, and

thread four M6x30 socket head screws (Item 10) through the holes on the
frame.Do not over-tighten. You can position for alignment after the left-side
panel (Item 1) and horizontal bar (Item 12) are installed.

4. Insert two M6 C'Bore butt fasteners (Item 11) in the slots in the right-side

panel.

5. Position the handset component on the right-side panel assembly (Item 7)

and connect the cable as done previously. Insert two M6X20mm socket head
screws (Item 12) and hand-tighten.

6. Repeat Steps 3 through 5 for the left-side panel assembly (Item 1)

7. When all of the above components are aligned, hand-tighten all the

fasteners.

8. Remount the sheet metal cover and rubber mat as done previously

9. Install the rear of the enclosure prior to mounting the lower horizontal bar

(Item 2) in the back of the enclosure with the M6 butt fastener (Item 3).
Then insert the back glass (Item 5) into the slots in the side panel, and install
the remaining two horizontal bars (Item 2) with the M6 butt fastener (Item
3).

10. Install the safety switch. Prior to assembling the safety switch mount plate

(Item 6), put the cable of the safety switch along the groove in a left-ward
direction. (The cable is pre-mounted in the slot of the right-side panel
assembly). Using two M6 X 20mm socket head screws and the M6 C'bore
butt fasteners, mount the safety switch mount plate to the side panel.

11. Position the safety switch (Item 4) with the arrow-on switch pointing

forward. Using the M4 x 35mm crossed discal screws and M4 washers,
mount the switch to the safety switch mount plate.

12. Place the front door (Item 13) into position and secure the hinges to the left-

side panel’s hinges.

13. Check for proper alignment of the safety switch and adjust as needed.

14. Remove the protective covering from the panels and door.

When the assembly is completed, it should look like the previous figure.

M6 C'bore Butt Fasteners

M6X20mm Socket Head Screw

Front Door

Sheet Metal Cover

Criterion_product manual.book Page 63 Monday, July 28, 2014 3:52 PM