2 system requirements, System requirements, Function library "lenzeio1000drv – Lenze Function library LenzeIO1000Drv User Manual
Page 6: 2system requirements

Function library "LenzeIo1000Drv"
System requirements
6
L
DMS 1.0 EN - 07/2011 - TD05
2
System requirements
Software
The function library can be used with the following Lenze software:
Supported target systems
Required libraries for use in »Drive PLC Developer Studio«
with Drive PLC/9300 Servo PLC/ECS:
Unless already available, insert the following libraries into the library management (menu
WindowLibrary management):
CANopenSdoDrvV10.lib
LenzeTICan9300V10.lib
LenzeIo1000DrvV10.lib
LenzeConversionBoxV10.lib (optional)
Product
Type designation
Version
Drive PLC Developer Studio
ESP-DDS2-x
2.x
PLC Designer V2
2.2 or higher
PLC Designer V3
ESPEVPDxxxxxx
3.x
Product range
Type designation
Hardware version
From software version
Drive PLC
EPL-10200
1A or higher
2.x
9300 Servo PLC
EVS93xx-EI
EVS93xx-ET
2M or higher
2.x
ECS
ECSxA
1B or higher
7.x
9400 ServoPLC
E94AxPExxxx
2A or higher
2.x
Note!
Before the "LenzeTICan9300V10.lib" library is inserted into the library manager,
the CAN_Management system block must be implemented into the Control
configuration.
If the CAN_Management system block is missing or implemented subsequently,
a compilation error may be caused during the project compilation.
Remedy: Remove "LenzeTICan9300V10.lib" library from the library manager,
implement the CAN_Management system block and re-insert the library into
the library manager.