Lenze E94AxHE Technology Application Electronic gearbox - Manual (Page 42)

9400 Technology applications | Electronic gearbox
Parameter setting & configuration
Selection of master value source and output
42
L
EDS94TA10030xxxx EN 1.2 - 11/2009
5.3.1 Master value source: Virtual master
If the "Virtual master" is selected as master value source, the master value is created in the
TA and transmitted via a bus system or the digital frequency output to the other slave
drives.
 Parameter setting: Tab Application parameters  dialog level Overview  Virtual
master
 Configuration: Tab FB editor  FB VirtualMaster
Parameter Lenze setting
Value Unit
C03565 Operating mode Continuous operation
C03568/1 Master speed 1 500.0000 unit/t
C03568/2 Master speed 2 0.1000 unit/t
C03569/1 Speed inching right 50.0000 unit/t
C03569/2 Speed inching left 25.0000 unit/t
C03570/1 Inching ramp 0.010 s
C03570/2 Continuous operation ramp 1.000 s
C03570/3 Stop ramp 1.000 s
Control/setpoint inputs of the function Signal configuration
Lenze setting Control/setpoint input (Multiplexer parameters)
FALSE  VMas master shaft STOP1 C03058/1
C03016  Activate master function C03058/3
C03017  VMas inching positive C03058/4
C03018  VMas inching negative C03058/5
FALSE  VMas start continuous operation C03058/7
FALSE  VMas 2. master speed C03058/8
0  VMaster handwheel C03056