Lenze Drive PLC Developer Studio 9300 Servo PLC (V8.x) - Manual (Page 75)

9300 Servo PLC
System blocks
2.12 MCTRL_MotorControl (node number 131)
2−61
L
9300 Servo PLC EN 5.0
Code IMPORTANT Possible settings LCD Code IMPORTANT
Selection Lenze
LCD
[C0084] Mot Rs à Stator resistance of the motor
à Dependent on C0086
·
If C0086 is changed, the value is
reset to the assigned Lenze setting
·
Change sets C0086 = 0
0.00 {0.01 W} 100.00
[C0085] Mot Ls à Leakage inductance of the motor
à Dependent on C0086
·
If C0086 is changed, the value is
reset to the assigned Lenze setting
·
Change sets C0086 = 0
0.00 {0.01 mH} 200.00
[C0087] Mot speed à Rated motor speed
à Dependent on C0086
·
If C0086 is changed, the value is
reset to the assigned Lenze setting
·
Change sets C0086 = 0
300 {1 rpm} 16000
[C0088] Mot current à Rated motor current
à Dependent on C0086
·
If C0086 is changed, the value is
reset to the assigned Lenze setting
·
Change sets C0086 = 0
0.5 {0.1 A} 500.0
[C0089] Mot frequency à Rated motor frequency
à Dependent on C0086
·
If C0086 is changed, the value is
reset to the assigned Lenze setting
·
Change sets C0086 = 0
10 {1 Hz} 1000
[C0090] Mot voltage à Rated motor voltage
à Dependent on C0086
·
If C0086 is changed, the value is
reset to the assigned Lenze setting
·
Change sets C0086 = 0
50 {1 V} 500
[C0091] Mot cos phi à Motor cos j
à Dependent on C0086
·
If C0086 is changed, the value is
reset to the assigned Lenze setting
·
Change sets C0086 = 0
0.50 {0.01} 1.00
C0111 Rr tune 100 % Adjustment of the rotor resistance
(Particularly recommended for
non−Lenze motors and high field
weakening.)
·
Adjustment in % of the rated rotor
resistance of the motor.
50.00 {0.01 %} 199.99