Lenze E94AYCEP - Manual (Page 13)

Lenze · E94AYCEP communication module (POWERLINK MN/CN) · Communication Manual · DMS 6.0 EN · 02/2014 · TD17
14
3 Product description
3.3 Product features
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.3 Product features
• Interface module for the POWERLINK communication system to be connected to the expansion
slots of the Servo Drives 9400
• The communication module can either be supplied internally by the standard device or
externally by a separate voltage source.
• Real time Ethernet with the POWERLINK V2 communication profile for motion and general
applications
• A line topology can be implemented by means of the integrated 2-port hub.
• Supported functions:
• POWERLINK MN (Managing Node)
• POWERLINK CN (Controlled Node)
• The "Managing Node mode" supports up to 50 nodes.
• Use of max. 10 PDO crosslinks for the Managing Node or the Controlled Node to create systems
with "distributed intelligence"
• Very short CN response times for optimal network performance
• Parallel Ethernet communication between the Lenze »Engineer« and the Servo Drive 9400 if a
POWERLINK router is used.
• Access to all Lenze parameters