C14079 | epl multi-stage node declaration cn, C14095 | epl communication status, C14079 – Lenze E94AYCEP User Manual
Page 112: 11 parameter reference

11
Parameter reference
11.3
Parameters of the communication module for slot MXI2
113
Lenze · E94AYCEP communication module (POWERLINK MN/CN) · Communication Manual · DMS 6.0 EN · 02/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C14079
C14095
Parameter | Name:
C14079 | EPL multi-stage node declaration CN
Data type: UNSIGNED_8
Index: 10496 = 0x2900
EPL index: See subcodes
This code indicates in which multiplexed cycle the Controlled Node is queried. The value entered must not exceed
the value in code
If, for instance, the value "3" is entered in code
, the multiplexed cycle is repeated every three cycles. If now
the value "3" is entered for one node in C14079/x, it is always queried only in the second cycle of the three
multiplexed cycles.
Setting range
(min. value | unit | max. value)
0
Cycles
255
Subcodes
Lenze setting
Info
EPL index
C14079/1
0 cycles
0x1F9B.0x01
...
...
...
C14079/100
0 cycles
0x1F9B.0x64
Read access Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT
Parameter | Name:
C14095 | EPL communication status
Data type: UNSIGNED_8
Index: 10480 = 0x28F0
EPL index: 0x1F8C
The code indicates the current NMT status of the EPL node.
Selection list
(read only)
Info
0 Off
NMT_GS_OFF
25 Initialising
NMT_GS_INITIALISING
41 ResetAppl
NMT_GS_RESET_APPLICATION
57 ResetComm
NMT_GS_RESET_COMMUNICATION
121 ResetConfig
NMT_GS_RESET_CONFIGURATION
28 NotActive
NMT_CS_NOT_ACTIVE
NMT_MS_NOT_ACTIVE
29 PreOp1
NMT_CS_PRE_OPERATIONAL_1
NMT_MS_PRE_OPERATIONAL_1
93 PreOp2
NMT_CS_PRE_OPERATIONAL_2
NMT_MS_PRE_OPERATIONAL_2
109 ReadyToOp
NMT_CS_READY_TO_OPERATE
NMT_MS_READY_TO_OPERATE
253 Operational
NMT_CS_OPERATIONAL
NMT_MS_OPERATIONAL
77 Stopped
NMT_CS_STOPPED (only Controlled Node)
30 BasicEthernet
NMT_CS_BASIC_ETHERNET (only Controlled Node)
Read access Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT