INFICON Cygnus Editor Software Manual - Manual (Page 66)

4 - 4
IP
N 07
4-
39
4-
P1
A
Cygnus Editor Operating Manual
Figure 4-4 Selecting Channels for display
4.2.2.2 Saving Data
Data can be saved automatically or by manual selection. By default, data is not
saved, based on the unchecked state of Auto Save Monitor shown in
Figure 4-5 .
Figure 4-5 Default is to discard all data collected
If Auto Save Monitor is checked ( Figure 4-6 ), then data is automatically saved
any time the data collection is stopped. This selection is maintained from session
to session by the program.
NOTE: When data is saved, it is written to a file and the file is closed. Any data
collected after the file is closed will be stored in a new file.
Figure 4-6 Auto Save Data enabled
Data can be saved at any time by pressing the Save As... toolbar button, which
saves all data collected since the Monitor was started, into one file. This selection
displays a standard Save As... dialog which allows for selecting the destination
folder and file name. By default, the file name is Monitor_yymmdd-xxx.sod where:
Š yy is the last two digits of the year
Š mm is the two digit month
Š dd is the two digit day
Š xxx is an index, starting at 000 and incrementing up to the maximum number
provided by the index digits (in this case, 999). By default, the index is three
digits, but can be changed on the System Properties >> Miscellaneous page.