INFICON Cygnus Editor Software Manual User Manual
Page 41
3 - 3
IP
N 07
4-
39
4-
P1
A
Cygnus Editor Operating Manual
Figure 3-3 Starting the Editor with Query Controller Cfg
NOTE: When the Query Controller Cfg command has been used, the Controller
front panel is essentially locked against any changes being entered. This
ensures that all parameters in the Editor, and any changes being made,
will be applied without conflict to the Controller. The "Locked" status of the
Controller is shown in the upper left corner of all Editor pages (see
). The "Locked" status can not be applied if, while editing a new or
existing Configuration, a single page is queried from the Controller without
having queried the entire Configuration first.
Figure 3-4 Controller Locked Status, example
If either File >> Edit Configuration or the Configuration Editor Icon is selected
to start the Editor then the dialog shown in
Figure 3-5
will be displayed. This allows
for a Controller to be specified as the target for a new or existing Configuration. To
open an existing Configuration file select Open; to create a new Configuration from
scratch select New. The item
the Edit Configuration dialog appears. To edit a configuration for a known
Controller (e.g. Cygnus 1 in
Figure 3-5
), highlight the Controller entry and press
Open. This will open a File Open dialog, as shown in
Figure 3-6
, in the appropriate
folder for this Controller.