INFICON Cygnus Editor Software Manual - Manual (Page 61)

3 - 23
IP
N 07
4-
39
4-
P1
A
Cygnus Editor Operating Manual
3.8 Editing Process Parameters
Figure 3-28 shows the Channel 1 Process Parameters for the Cygnus Editor. The
Process Parameters page sets the Process Parameters that are specific to a
Channel for the Cygnus Controller.
Figure 3-28 Process Parameters Page
To edit any parameter, enter the desired value in the Value column or use the
corresponding pulldown or spinner. Some parameters are disabled because they
are dependent on the settings of other parameters. Any parameter can be sent to
the Cygnus Controller by selecting the parameter in the Send column and pressing
the Send Selection button. The entire page of parameters can be sent by pressing
the Send All button. The OK button will save all changes to the Editor memory; the
Cancel button will discard all changes.