INFICON Cygnus Editor Software Manual - Manual (Page 47)

3 - 9
IP
N 07
4-
39
4-
P1
A
Cygnus Editor Operating Manual
3.4 Editing the General Parameters
Figure 3-10 shows the General Parameters page of the Cygnus Editor. This
page sets the parameters that are not specific to any of the Cygnus channels.
Figure 3-10 General Parameters Page
To edit any parameter, enter the desired value in the Value column or use the
corresponding pulldown or spinner. Any parameter can be sent to the Cygnus
Controller by selecting the parameter in the Send column and pressing the Send
Selection button. The entire page of parameters can be sent by pressing the Send
All button. The OK button will save all changes to the Editor memory; the Cancel
button will discard all changes.
For specific information on any General Parameter, refer to the Cygnus Thin Film
Deposition Controller Operating Manual (IPN 074-379).