7 how to install the cygnus editor – INFICON Cygnus Editor Software Manual User Manual

Page 14

1 - 6

N 07

Cygnus Editor Operating Manual

1.7 How To Install The Cygnus Editor

Install the Cygnus Editor from within Windows as follows:

NOTE: To install the Cygnus Editor on a system running Windows 2000 or XP

system you must have Administrative or Standard user rights.

NOTE: This description assumes your CD-ROM drive is drive “d”. If it is not “d”,

substitute the appropriate drive letter.

Insert the CD into the CD-ROM drive.

Select Start >> Run... to display the Run dialog

In the Open field, type

d:\setup

Select OK.

When you are prompted, answer the questions. See note at bottom of page.

NOTE: If during the installation you are prompted to replace a system file (e.g.

a DLL file), it is recommended that the file be replaced. Normally this
prompt is only presented if the file on the hard disk is older than the file
on the installation disk. The newer version should still work with older
programs that use this file; however, if you are concerned that it may
cause problems, then you can abort the installation, save a copy of the
file in question, and restart the installation program. The Cygnus Editor
may not function properly if all files are not installed.

When the installation is complete, put the original CD in a safe storage area.