INFICON HLD6000 Refrigerant Leak Detector - Manual (Page 50)

50
6 Operation
Tr
an
sl
ation
o
f the
o
rig
in
al
operatin
g
in
str
u
ct
io
ns
HLD
6000
, k
ina4
3
e1-
a
, 140
8
3 View the desired information. These include, for example
– under "Basic Unit" there is information regarding the software version, the serial
number of the device, the operating hours and the interior housing temperature,
– under "COOL-Check" there is information regarding the leakage rate depending on
temperature and on the remaining time of use available,
– under "Sniffer Line" there is information regarding the software version, the serial
number and the gas used,
– under "Operating Unit" there is information regarding the operating system and the
software version.
4 To view all information, press on the page numbers displayed below.
6.7.1 Parameter list
It is possible to display all settings for the device. For changes the necessary permissions
are required,
see "6.3.10 Access to the settings", page 39 .
With the aid of the parameter list several changes can be carried out in one area without
navigating through various menu trees,
see "10.2 Menu trees", page 68 .
1 To create the parameter list, select " > Parameter List".

Alternatively, select " > Parameters > Parameter List".
The following parameters are displayed:
– Analog output upper limit see "6.3.8.3 Setting the upper scale value for 10 V of the
analog output", page 37 ,
– Display off after, see "6.3.5 Setting the display", page 35 ,
– Display brightness, see "6.3.5 Setting the display", page 35 ,
– Display maximum value (log.) exponent see "6.3.5 Setting the display", page 35 ,
– Display maximum value (lin.), see "6.3.5 Setting the display", page 35 ,
– Display upper limit (lin.), see "6.3.5 Setting the display", page 35 ,
– Display upper limit (log.) exponent, see "6.3.5 Setting the display", page 35 ,
– Display unit leakage rate, see "6.3.5 Setting the display", page 35 ,
– Auto scale, see "6.3.5 Setting the display", page 35 ,
– Screen tap sound, see "6.3.3 Adjust volume", page 34 ,
– BUS module address (in planning phase)
– Data record, see "6.4.8 Measured data", page 47 ,
– Date, see "6.3.2 Setting date and time", page 34 ,
– Diagram of the leakage rate, see "6.3.5 Setting the display", page 35 ,
– User Gas Factor 1, see "6.4.4 Setting up the gas for the SMART sniffer line", page 42 ,
– User Gas Factor 2, see "6.4.4 Setting up the gas for the SMART sniffer line", page 42 ,
– User Gas Factor 3, see "6.4.4 Setting up the gas for the SMART sniffer line", page 42 ,
– Error information operator, see "6.3.9 Set up scope of error messages", page 38 ,
– Error information supervisor, see "6.3.9 Set up scope of error messages", page 38 ,
– Filter change request, see "8.2.1 Replacing the filter holder", page 63 ,
– Gas in the SMART sniffer line, see "6.4.4 Setting up the gas for the SMART sniffer line",
page 42 ,
– I/O module protocol, see "6.3.8 I/O module", page 36 ,
– Interval for auto standby, see "6.3.4 Setting auto standby", page 35 ,