ETC UpdaterAtor v3.0.0 - Manual (Page 6)

E T C Q u i c k G u i d e :
UpdaterAtor Software
UpdaterAtor Software Page 6 of 8 Electronic Theatre Controls, Inc.
A display will open with all of the devices that can be updated via the dongle.
The software for the devices can be downloaded from the Setup Versions display, see Setup
Versions Display on page 4 .
Click on the device you wish to update, then click {Next}.
The screen you will see next will depend upon which device you are updating. There are slightly
different update processes for each device. Each screen will guide you through the steps for
updating. Once complete, click {Finish} to return to the Main Window display.
Updating Supported RDM Devices Using a Net3 Gateway
If UpdaterAtor discovers Net3 Two Port or Four Port
Gateways, that are running version 5.1 or later, an additional
button, {RDM Devices} will display on the main window
display.
Click {RDM Devices} to update. The RDM wizard will open. The wizard will guide you through the
If the software for the device is not
found on your computer, this warning
will be displayed.