ETC UpdaterAtor v3.0.0 - Manual

E T C
®
Q u i c k G u i d e
UpdaterAtor Software
UpdaterAtor Software Page 1 of 8 Electronic Theatre Controls, Inc.
Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736
London, UK  Unit 26-28, Victoria Industrial Estate, Victoria Road, London W3 6UU, UK  Tel +44 (0)20 8896 1000  Fax +44 (0)20 8896 2000
Rome, IT  Via Pieve Torina, 48, 00156 Rome, Italy  Tel +39 (06) 32 111 683  Fax +44 (0) 20 8752 8486
Holzkirchen, DE  Ohmstrasse 3, 83607 Holzkirchen, Germany  Tel +49 (80 24) 47 00-0  Fax +49 (80 24) 47 00-3 00
Hong Kong

Rm 1801, 18/F, Tower 1 Phase 1 Enterprise Square, 9 Sheung Yuet Road, Kowloon Bay, Kowloon, Hong Kong

Tel +852 2799 1220

Fax +852 2799 9325
Service: (Americas) [email protected]  (UK) [email protected]  (DE) [email protected]  (Asia) [email protected]
Web: www.etcconnect.com

Copyright © 2012 ETC. All Rights Reserved.  Product information and specifications subject to change.
5000M1310-3.0.0  Rev A  Released 2012-07  ETC intends this document to be provided in its entirety.
Overview
This Quick Guide will guide you through the setup and operation of the UpdaterAtor Software.
UpdaterAtor allows the remote update of a variety of ETC products over the network. The
supported products include:
• Sensor ® CEM3
• Sensor ® CEM+
• Matrix
®
Mk2 Processors
• Net3
™
DMX Gateways
• Net3 Show Control Gateways
• Net3 I/O Gateways
• Net2
™
Two Port Nodes
The following products can be updated by UpdaterAtor using the ETC USB-RS485 dongle, ETC
part number 5000A1039:
• Source Four LED
• Selador
®
Desire
™
• Source Four Revolution
®
• SmartPack ®
• SmartBar ® 2
• SmartModule
®
2
• SmartSwitch
™
The following products can be updated by UpdatorAtor using a Net3 Two port or Four port
gateway:
• Source Four LED ™
• Selador
®
Desire
™
Computer Setup
In order to update Net3 Gateway products running in Net3 mode, Gateway Configuration Editor
(GCE) must also be installed. For all other products, UpdaterAtor can download the latest
software, transfer software to removable drives, and update devices.
It may be necessary to change the IP settings in the network adapter properties in order to
connect to an ETC lighting network. In a standard ETC network the following default settings
should be used for your computer:
• IP Address: 10.101.1.101
• Subnet Mask: 255.255.0.0
• Default Gateway: 10.101.1.1
N o t e : For information on configuration of your computer’s IP settings, please reference
the help documents for your operating system.
N o t e : UpdaterAtor needs access through any firewalls. When installing on a computer
running Windows 7, make sure to select all three options as shown below.