ElmoMC SimplIQ Digital Servo Drives-Whistle DC Installation Guide - Manual (Page 49)

DC Whistle Installation Guide Installation
MAN-DCWHIIG (Ver. 1.101)
www.elmomc.com
49
3.13. Powering Up
After the cables have been connected to their devices, the DC Whistle is ready to be powered
up.
Caution:
Before applying power, ensure that the DC supply is within the range specified
and that the proper plus-minus connections are in order.
3.14. Initializing the System
After the DC Whistle has been connected and mounted, the system must be set up and
initialized. This is accomplished using the Composer, Elmo’s Windows-based software
application. Install the application and then perform setup and initialization according to the
directions in the Composer Software Manual.