Despatch LCC/LCD2-14-4 Oven Series with Protocol 3 - Manual (Page 39)

LCC/LCD2-14 Series Oven Owner’s Manual O PERATION
Version 1 39
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
The two shelves are designed to be pulled out about halfway without tipping. Do not overload the
shelves. Distribute the workload evenly so airflow is not restricted. Do not overfill your oven.
The workload should not take up more than two-thirds of any dimension of the inside cavity.
5.2. Pre-Startup Checklist
□ Know the system. Read this manual carefully. Make use of its instructions and explanations.
Safe, continuous, satisfactory, trouble-free operation depends primarily on your degree of
understanding the system and your willingness to keep all parts in proper operating condition.
□ Check line voltage. Voltage must correspond to nameplate requirements of motors and
controls. A wrong voltage can result in serious damage. Refer to Section 1.5.4 for more
information.
□ Check fresh air and exhaust openings. Do not be careless about restrictions in and around the
fresh air and exhaust openings and stacks. Under no condition can they be permitted to
become so filled with dirt that they reduce airflow.
Warning!
Do not use flammable solvent or other flammable material in this
oven if it is not Class A. Do not process closed containers of any
substance or liquid in this oven because they may explode under
heat.

For LCC/LCD2-14 Class A ovens, the purge timer is preset with
the time listed on the nameplate at the factory.