Checking the printer voltage, 120 v, 230 v – Dascom T2150 User Guide User Manual
Page 17: User guide installation, Front side of the printer rear side of the printer
User guide
Installation
7
Checking the printer
voltage
Make sure that the device has been set to the correct voltage (e.g.
230 V in Europe, 120 V in the USA). To do this, check the type plate
above the power inlet at the back of the printer. Contact your dealer
if the setting is incorrect.
Never switch on the printer if the voltage setting is incorrect,
since this may result in severe damage.
You can set the printer to the correct mains volta-
ge yourself. To do this, cautiously tilt the printer to
the rear.
Make sure that the fixing clips of the
parallel connection are not bent.
Use a suitable object (e.g. a screwdriver, but
never a pencil) to set the slide switch on the left at
the bottom of the printer to the correct voltage.
STOP
n
e
p
o
o
t
ll
u
p
n
e
p
o
o
t
ll
u
p
STOP
120 V
Front side of the printer
Rear side of the printer
230 V