Dascom T2150 User Guide - Manual (Page 115)

User guide Care and maintenance
105
Care and maintenance
The printer is designed to operate with minimal maintenance. It is
advisable to clean the inside of the printer from time to time with a
vacuum cleaner.
Before cleaning, turn off the printer, wait 5 to 10 seconds and
disconnect the power cable.
Do not oil or grease the printer, especially the sliderails and
shafts.
Replacing the fuse
The printer is provided with a power supply fuse which is accessible
directly from the outside.
Open the small compartment below the power supply connector with
a screwdriver and pull out the compartment completely. Remove the
defective fuse and replace it by a new fuse of the same type.
The fuse ratings are specified on the printer type plate which is
mounted above the power connector on the rear:
T2,5AH/250V
11
STOP
STOP