COATS ProRide Wheel Balancer - Manual (Page 7)

Important: Always read and follow instructions. • 3
66-inches (1664mm)
Machine Set-up
CAUTION
Do not use the control panel, control panel
base, accessory storage, faceplate, hood or
shaft to lift the balancer.
CAUTION
Do not attempt to install and set-up the unit
yourself. Contact COATS as noted below.
A factory trained COATS Service Technician must per-
form the install, set-up, and initial test procedures on
your wheel balancer. Do not attempt to install and set-
up the unit yourself. Accurate and reliable operation of
your unit depends on proper installation. Please contact
COATS directly at 1-800-688-9240 for the Certified
Service Partner nearest you.
Floor and Space Requirements
The balancer must be located on a flat floor of solid
construction, preferably concrete. The balancer must
sit solidly on its three feet. If the balancer is not level,
does not sit solidly on its three feet, or is placed on an
unstable floor, the balancer will not function properly
and may produce inaccurate balance readings.
Do not operate the balancer while it is on the pallet.
Select a location for the balancer that provides a level,
solid floor, and adequate clearance around and above
the balancer. Make sure the location selected has
enough room above and behind the unit so the hood
can be raised completely. The location must also pro-
vide working room for mounting and removing wheels.
Make sure the area has adequate lighting.
Connect to Power
Your factory trained COATS® Service Technician should
do the final check to verify the power installation before
connecting the balancer to a power supply. Failure due
to improper power connection may void the warranty.
59-inches (1505mm)
49-inches
(1230mm)
60-inches
(1513mm)