COATS 6200HS Truck Wheel Balancer User Manual
Page 6
iv
Coats Model 6200HS
Setup
The balancer is programmed before leaving the factory
to display weight imbalance in grams. To change this
setting to ounce units, press oz/gram button, a decimal
point appears in the Display Window (0.00). Repeating
these steps will change the units back to grams (000).
Weight Increment Selection Mode
Machine is shipped in 25g (1oz) Increments to switch
to 50g (2oz) Increments, follow this procurdure.
1. With the machine powered off press and hold the
mode button.
2. Turn the power back on while still holding down
the mode button, wait about 7 seconds for the
machine to beep, machine is now in 50g (2oz)
increments.
Maintenance
1. Clean mounting accessories, mounting surface,
and spindle of balancer regularly. Grease and oil
accumulate dirt which can cause incorrect balance
results, and also act as a grinding compound
resulting in premature wear.
2. A light coating of grease should be maintained on
the sliding contact faces of the lifting section.
3. Remove wheel weights and rubbish from under
the balancer.
4. Do not lean any tyres, rims, tools or other parts
against the balancer.
5. Clean the Control Panel and Display Window with
window cleaner.