COATS 6200HS Truck Wheel Balancer - Manual (Page 4)

ii
Coats Model 6200HS
SAFETY CAUTIONS AND WARNINGS
1. Read the Operators Manual before operating the
balancer for the first time. Follow all instructions
and warnings marked on the product.
2. The balancer operates from a) 110Vac, 60 Hz
wall outlet with the supplied 8.5Vac power
converter b) 12Vdc supply. Do not use any other
electrical sources. Use only an EARTHED
electrical power source. Use only a correctly rated
replacement fuse .
3. Arrange the power cord so that it will not be tripped
over or pulled, and keep it clear of moving parts.
If an extension cord is used, ensure its current
rating equals that of the power cord supplied.
Immediately replace a damaged power cord.
4. Ensure the balancer rests on all three feet on a
clean, level floor with no debris under the base.
5. Do not operate the balancer: a) near fumes or
exposed flammable liquids; b) on wet surfaces.
Do not expose the balancer to rain.
6. Adopt the correct lifting procedures when lifting
any object. Weights in excess of 100lb (45kg)
should not be lifted unaided.
7. NEVER remove a cover or access panel on the
balancer without first disconnecting the balancer
from the electrical power source.
8. Only authorized and trained operators should use
the machine.
9. Wear approved eye protection when removing or
attaching weights. Keep hair, clothing and all parts
of the body clear of balancer moving parts.
10. Remove all stones, old weights, and other debris
from the wheel before balancing.
11. Centre and tighten the wheel on the shaft before
spinning the wheel.
12. Check that all wheel weights are properly applied
and secured.
13. The balancer will return to the normal power-up
state if the power is interrupted.
14. When the balancer is not in use, disconnect the
power cord and use the available pegs and trays
for storage of accessories.